Samsung J500h Dead Boot Repair Too many errors Writing has been stopped

Samsung J500h Dead Boot Repair Problem

HiPower mode is OFF

Frequence: 14 Mhz

CMD Pullup Level: 2134 mV

CMD Active Level: 2774 mV

EMMC Device Information :

EMMC CID: 150100514E31364D420057A7565B724C

EMMC CSD: D02701320F5903FFF6DBFFEF8E40400C

EMMC Manufacture Name: SAMSUNG

EMMC Manufacture ID: 0x15 , OEM ID: 0100

EMMC Manufacture Date: 7/2015 , Rev: 00

EMMC NAME: QN16MB , S/N: 57A7565B , rev. 00

EMMC NAME (HEX): 514E31364D42

   EMMC ROM 1 (Main User Data) Capacity: 7456 MB (0001D2000000)

   EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)

   EMMC RPMB (Replay Protected Memory Block) Capacity: 512 KB (000000080000)

EMMC Permanent Write Protection: No

EMMC Temporary Write Protection: No

Extended CSD Information :

Extended CSD rev: 1.7 (MMC 5.0, MMC 5.01) 

Boot configuration [PARTITION_CONFIG]: 0x00 , Boot from: no boot

Boot Bus Config: 0x00 , width 1bit

H/W Reset Function [RST_N_FUNCTION]: 0x00, RST_n signal is temporarily disabled

Supported partition features [PARTITIONING_SUPPORT]: 0x07

Device supports partitioning features

Device can have enhanced technological features in partitions and user data area

Device can have extended partitions attribute

Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00

Backup saved: QN16MB_57A7565B_20171116_001923.extcsd

EMMC Init completed.

Operation: Write by vendor (Samsung)

Creating GPT-partitioninig

Writing PIT at address: 000000004400

GPT-partitioning done

Unpacking file: non-hlos.bin

Unpacking file: sbl1.mbn

Unpacking file: aboot.mbn

Unpacking file: rpm.mbn

Unpacking file: tz.mbn

Unpacking file: hyp.mbn

Unpacking file: sec.dat

Partition name: APNHLOS

Filename: non-hlos.bin , Offset: 000000400000 , filesize: 12076800 bytes

eMMC switching to ROM1

Erasing partition...

Error erasing at address: 000000500000 ... Retry #1

Error erasing at address: 000000500000 ... Retry #2

Writing partition...

Error writing at address: 000000400000 ... Retry #1

Error writing at address: 000000400000 ... Retry #2

Error writing at address: 000000400000 ... Retry #3

Too many errors. Writing has been stopped